Cart 0
LiveHouse Automation :GOAP Z-Wave Tubular Motor Controller DC,GOAP

Qubino Z-Wave Shutter Controller DC


  • $9900
  • Save $10

The Qubino Z-Wave Shutter Controller DC is the world's smallest Z-Wave module able to control 12-24V DC motors of blinds, rollers, shades and Venetian blinds.

  • Z-Wave Plus certified
  • Supports the connection of a temperature sensor
  • Can measure the power consumption of connected device

    The Qubino Z-Wave Shutter Controller DC is a Z-Wave Plus (500 series) controller for blind, roller and shade motors with 12-24V DC motors. It is designed to fit into an existing switch and enables you to wirelessly control blind motors using a Z-Wave enabled (921.42 MHz in AUS/NZ) controller and reports the motors actual power (Watts) and total power consumption (kWh). This device also supports precise positioning for motors equipped with mechanical or electronic switches.

    The Qubino Z-Wave Shutter Controller DC allows the connection of a temperature sensor which can report the local temperature to your Z-Wave gateway allowing it to better meet your heating/cooling needs.

     This product integrates with all Australian certified (921.42 MHz) Z-Wave Controllers including;

    • Vera Edge/Plus
    • Fibaro Home Center 2/Lite

    Configuring Z-Wave Devices:

    Z-Wave devices often have several configurable parameters which you can change using your Vera’s user interface. These parameters can include things such as the length of time a Z-Wave siren remains active for or the type of manual switch connected to a Z-Wave light controller.

    Every available configurable parameter is listed in your device’s user manual. In most cases your device’s default parameters will be suitable to your needs however sometimes it may be necessary to adjust them to optimally use your device. A guide to configuring Z-Wave devices with Vera UI7 is available in the Manuals section. 

    Qubino is manufactured by GOAP in Europe.

    RF Protocol
    Z‐Wave Plus (500 series chip)
    RF Frequency
    921.42Mhz ‐ AU/NZ  approved RF for Z‐wave
    Z‐Wave device type
    Z-Wave binary switch, routing slave
    12-24V DC ± 10%
    2 x 920W (4A resistive @ 230V AC)
    Power Consumption
    < 0.7W
    Operation Range
    Up to 30m indoors (with no obstacles)
    Indoor use only
    Operation temperature
    10 ~ 40 °C
    Storage temperature
    ‐10 ~ 60 °C
    41.8mm x 36.8mm x 16.9mm 


    Rated Load Current 
    Overcurrent Protection
    Output circuit power of DC output (resistive load)
    48W (24V DC)


    Manuals and Downloads

    PDF: User Manual

             Guide to Configuring Z-Wave Devices with Vera UI7

    Video: Youtube 










    Have a Question?

    Be the first to ask a question about this.

    Ask a Question

    We Also Recommend