Cart 0

Qubino Z-Wave On/Off Thermostat


  • $10400

The Qubino Z-Wave ON/OFF Thermostat is ideal for directly controlling electric or water-based heating systems such as electric water heaters or hot water pumps.

  • Z-Wave Plus certified
  • Includes digital temperature sensor
  • Can measure the power consumption of connected device (within 3% accuracy)
  • Extremely low energy consumption (less than 0.4W)
  • Frost free mode: Specifies a minimum temperature for the heating system connected to the module to prevent your pipes from freezing.

The Qubino Z-Wave ON/OFF Thermostat  can be used to directly control electric or water-based underfloor heating systems, electric water heaters, hot water pumps, electric radiators and similar. You can control it either remotely through the Z-Wave network or through wall switches.

The Qubino Z-Wave ON/OFF Thermostat  also measures power consumption and supports the connection of a digital temperature sensor.

 This product integrates with all Australian certified (921.42 MHz) Z-Wave Controllers including;

  • Vera Edge/Plus
  • Fibaro Home Center 2/Lite

Configuring Z-Wave Devices:

Z-Wave devices often have several configurable parameters which you can change using your Vera’s user interface. These parameters can include things such as the length of time a Z-Wave siren remains active for or the type of manual switch connected to a Z-Wave light controller.

Every available configurable parameter is listed in your device’s user manual. In most cases your device’s default parameters will be suitable to your needs however sometimes it may be necessary to adjust them to optimally use your device. A guide to configuring Z-Wave devices with Vera UI7 is available in the Manuals section.

Qubino is manufactured by GOAP in Europe.


RF Protocol Z‐Wave Plus (500 series chip)
RF Frequency 921.42Mhz ‐ AU/NZ  approved RF for Z‐wave
Z‐Wave device type Z-Wave binary switch, routing slave
Power Supply 230V AC ± 10% OR 24-30V DC
Rated Load Current of AC Output (resistive load) 1 x 10A / 230V AC
Rated Load Current of DC Output (resistive load) 1 x 10 A / 30V DC 
Output circuit power of AC output (resistive load) 2300W (230V AC)
Output circuit power of DC output (resistive load) 240W (24V DC)
Operation Range Up to 30m indoors (with no obstacles)
Application Indoor use only
Operation temperature 0 ~ 40 °C
Storage temperature ‐10 ~ 60 °C
Weight 48g
Dimensions 41.8mm x 36.8mm x 15.4mm 

GOAP Z-Wave On/Off Thermostat - User Manual


    Have a Question?

    Be the first to ask a question about this.

    Ask a Question

    We Also Recommend